1. Start with the following conditions: you are in the vehicle
a. Key is out of the ignition
b. Drive door is open ( all other doors are closed)
c. Driver door is unlocked (other door locks don't matter)
2. Insert the key into the ignition (don't turn it) and pull it out.
3. Perform these steps within 40 seconds:
a. Cycle the power locks 5 times. Use an even pace and try
to go relatively fast.
b. Close, then open the drivers door.
4. Perform these steps within 40 seconds:
a. Cycle the power locks 5 times (same as before).
b. Turn the ignition to ON then back to OFF.
c. Turn the ignition to ON then back to OFF.
d. Remove the key from the ignition.
5. Within 3 seconds, the power door locks should cycle (automatically)
indicating successful entry into programming mode. Return to step 1
if the locks do not cycle at this point.
6. Perform these steps within 40 seconds:
a. Press the LOCK and UNLOCK buttons on the transmitter
simultaneously for 1 second.
b. Immediately after letting go of the lock and unlock buttons,
press the lock button by itself and hold for 2 seconds.
Within 3 seconds, the door locks should cycle ( LOCK then
UNLOCK) once-- indicating successful programming. If
the door locks don't cycle, or cycle twice. Repeat steps
6a and 6b--this remote has not been accepted.
c. Repeat steps 6a and 6b for EACH transmitter that will
operate the vehicle. Including any old transmitters.
7. Close the driver door.
Hope this helpsWhat are the programming instructions on a keyless remote for a 98 toyota 4runner?I remember doing this on my bros car
open drivers side door
stick the key in the ignition then pull it out
lock and unlock the door 5 times (making a total of 10 button pushes)
shut and then open the door
lock and unlock the door 5 times (making a total of 10 button pushes)
stick the key in the ignition and turn to on then off then on then off (this can vary from 1, 2, 3, or 5 times. try them all)
pull the key out of the ignition
you should hear the door locks go clunk clunk (lock and Unlock)
press the two top buttons on the remote for 1 second
then press the unlock button by itself for 1 second then repeat the pressing process for the second remote
No comments:
Post a Comment